ASA5520 SSH access

[cisco_lad2004]

Dear all

I am adding a new jump station to the network which is supposed to connect via ssh only to ASA.

using ASDM, I add teh host address of jumpstation under properties, device access, secure shell and apply. easy enough, but does not work...any suggestions ?

TIA

Sam

[JORGE RODRIGUEZ]

Sam, I assume you have configured crypto keys for ssh access as this is required for ssh access to security applience. If you have done so on this part I would then believe something wrong in your ssh added statement rule.

asa(config)#ssh < mask>

make sure ssh statement for jumpstation is comming from correct nameif interface.

examples

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008069bf1b.shtml

regards

[cisco_lad2004]

Thanks for the response !

I found out teh config was correct, but DNS was point at wrong FW interface. and therfeore requests are dropped.

Sam