cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1047
Views
0
Helpful
1
Replies

ASDM in Firewall Transparent mode

rosswmerrifield
Level 1
Level 1

Greetings,

I would like to configure an ASA5512-X in firewall transparent mode, but I am having trouble getting ASDM to lauch when I do.

I have created a BVI interface with an IP address, and I hve enabled the mangement interface, but ASDM does not lauch when I enter the IP adress of the BVI I created.

Apprently you need to use the bridge-group command to assign an interfce to a bridge group. When I enter this command at the (config-if) prompt for Management 0/0, this command is not recognized.

What are the general steps for configuring the management interface to be able to launch ASDM in transparent mode?

Thanks,

-Ross Merrifield

1 Reply 1

Julio Carvajal
VIP Alumni
VIP Alumni

Hello Ross,

The managment interface itself is only used for managment purposes ( it has it's own Ip address) So configured it differently from any other interfaces ( Assing an ip to that managment interface like you will do with a regular ASA interface ( not on bridged mode) )

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: