at this point if we are in the context admin, we are unable to ping the svi on vlan 192 (10.65.192.1) but of course we ping local interface sucessfully.
same problem on int 196.
we put access list permit ip any any in on both interface but this not resolve.
when on MSFC, we ping local but we dont ping fwsm int192 on the same vlan. strangely, the sh arp command show the ip of the FWSM in router and same command show svi ip in the FWSM. Also, we are unable to telnet from 10.65.192.x to the FWSM.
Do we need something else to permit these elementary things ? we dont set up any nat command at this point.
We also suspect problem communication between the FWSM module and the switch, but if it would be the case, i dont think we would see other module MAC adresse in the arp table.
HIDoes anyone know if there is an easier way than the belowQ. I check connection events for IOC's when requested and sometimes i have to check many url's which i am presently doing one url at a time and is very time consuming, is there a way to check mult...
Cisco Identity Services Engine (ISE) gives you intelligent Integrated protection through intent-based policy and compliance solution. ISE supports external MDM vendor integration to help the customers to look for compliance of a dev...
This video provides the steps to configure the Cisco Threat Response (CTR) and ESA Integration.
This is live on the portal:https://video.cisco.com/video/6159336218001
And on YouTube:https://www.youtube.com/watch?v=UCKIdx5rdFg
I need to migrate from C170 to C190 and have already match to the same Firmware Version. I have a question. Is there any method that can export and import the configuration file instead of form cluster ?