Hi guys, I have two 5506 boxes running 9.8.3 patch 29. I login first time with ASDM and perform whatever tasks.I left ASDM open and move to other windows (probably a browser); after couple minutes a pop up from ASDM login credetials shows up. Obvious...
I have a pair of 4110s, and I had a problem SSHing to the logical ASA's. Having looked at the licensing, it appears that the "Encryption-3DES-AES" is disabled, which is causing it to only accept SSHv1 connections. The problem is, i don't have access ...
Hello team, I am new to Cisco ACI World and I have been asked to integrate Fortigate FWs in HA with the ACI factory. Reviewing the equipment's Datasheet, it comes with 6 QSFP ports to make connection with the ACI factory, but could you tell me, accor...
All, Forgive the newbie here (when it comes to Cisco devices), but our company purchased several ASA5505 firewalls with bundled licenses. My question is, how do I get these licenses? I'm on the license page (http://www.Cisco.com/go/license) but fro...
Hello.I have ASA5506-X with FTD image installed. I connected it to my smart account and now activate 3DES license (PAKs or Tokens->Get Licenses->Crypto,IPSec->Cisco ASA 3DES/AES License->[enter sn]->next).Then: Add new PAK->[fill PAK, pin]->finish. C...
Hi,can the Cisco ASDM Launcher for accessing the ASA only be used with the Oracle JRE ? Since the latest Oracle JREs are no longer free we're wondering if you can use another JAVA JRE such as Zulu or OpenJDK to use the Cisco ASDM launcher.Is that pos...
Hello. I installed Firepower 3110. I checked it had 900GB SSD, but I could check only 16GB in ASA. 16106127360 bytes total (14880862208 bytes free) Is it normal?
Is there any plan to support ASDM on Windows server 2016 OS?
Hi, the FTD software (6.2.3.10) on ASA 5506-X does not seem to support point-to-point (/31) ipv4 subnets. When trying to set my static /31 public ip on the outside interface in FDM the error message "You cannot assign a broadcast address as the IP ad...
hi guys, we are facing issue with our ASA 5515x which was working fine but after enabling Unicast Reverse Path Forwarding and removing some weak encryption/hashing Transform-set, now all traffic is being blocked by Implicit Deny rule from all interfa...
Hi,I've configured an ASA 5506X with 2 VTI tunnel interfaces to a cloud provider, and I'm getting asymmetric routing (which is to be expected at times). Now, the issue I would like to solve is to tell the ASA to be able to perform stateful inspection...
Hello Everyone! I am trying to configure our anyconnect VPN clients to relay to a windows DHCP server. I have about 15 DMZ relays and 20 802.1x relays that work fine from the inside. However I am having trouble getting the VPN clients to relay. I hav...
Could anyone explain what is the difference between "service resetoutbound" and "service resetoutside"? And when should I enable "service resetoutbound"? When should I enable "service resetoutside"?
Is there a way to do a factory reset on this FPR1010? The original problem I have is I can ping both 192.168.1.1 and .45.45 but I'm not able to reach the page via browser. "This site can not be reached" I'm able to communicate via USB console though...
Hello All,Looking for some help . All was ok up until today and nothing has changed in the server room . We have a valid contract with smartnet/any connect until Nov2020. Suddenly today my users are experiencing the attached error msg when trying to ...
