Hello everyone,I have a problem with an IOS firewall. The thing is that I'm using an FTP client to collect data from the wan (it's on passive mode). The session gets established, through port 21 (wich is on my access-list). I cannot get the transfer ...
Hello! Does anyone know if there's an easier way to configure and create rules that require manual entry in the FMC policy creation dashboard? We are working on a migration from the ASA which has over 300 rules and our company would also like to reca...
Hi,Please I need an advise to determine the right NGFW based on the below requirements:- Each NGFW physical appliance should provide minimum of 240 Gbps Firewall throughput.- Each NGFW physical appliance must support minimum of 850,000 new TCP connec...
This question has been asked a couple of other times, but no one has ever answered it. I am bringing up an AWS instance running the Cisco ASAv 9.9.2.1 application, but I am unable to ssh into the resulting instance.I am following the instructions pro...
I have an ASA on which I'm trying to use PBR to route to one of two ISPs which I'll call "slow" and "fast." The interface to the slow ISP is connected to a subnet on which the next-hop address is clearly in the subnet and it would count as "directly ...
Hello allI'm receiving hundreds of warning messages i am getting in our syslog from our Cisco ASA 5516-x. The warning message are on below same as screenshots and dunt know how to act with these kind of massages as its huge numbers of massages coming...
If I am configuring an IKEv1 IPSEC site-to-site VPN with an FTD device running 7.4.1 managed by the FMC and it is policy based, not route based, does the system ACL applied to the device also control the traffic across the tunnel? If so, then what Zo...
Hi Guys, Tried to perform the reimage of the Cisco 5525-x firepower module to 6.0.0 but failed. I've setup the ftp server(filezilla) and uploaded the boot image to disk0 parttion without any issue, however, perform system image ftp://username:passwo...
Hello, Does anyone know why the FMC/FTD would create an sf-storage folder on a Linux Server? When I configured the remote storage I tried to point it so that the backups are stored into a certain directory, however it created a separate folder within...
Hello, I deployed a new FTD 2110 on our company network and I'm seeing two different mac addresses on the switch port that the MGMT interface is connected to. I know that the one mac address is associated with the actual MGMT interface, but can anyon...
Working on a pair of 2130s in HA that have the URL filtering license and there is also an SSL Policy in place. YouTube isn't blocked, but there is 1 particular video that when trying to view it you get the following error: The same URL when on a co...
Hello,I've bee trying for a while to get my FMC to talk to remote storage so I can place my backups and reports there. For some reason my FMC refuses to talk to any remote storage device I have. NFS, SMB (haven't tried SSH), neither work. I keep get...
Hello,We have a cisco asa 5510 Firewall running the latest version 9.1(7)23 connected to our Office through an IPSec VPN Tunnel, and we are trying to configure a new management machine to connect remotly to the management ip address of the firewall, ...
What would be the best way to capture traffic on a subnet (192.168.1.0/24) and excluding the capture for one of the IPs withing this subnet (192.168.1.1) Reason is I want to run the capture for a couple of days and 192.168.1.1 will fill up the buffer...
Hi i have been given some tasks to do but i can't find anything that can really guide me i tried checking the documents in the main cisco website but it is not really that helpful, now i want these tasks to be done if somebody can just guide me i hav...
