Network Security

Hi, Just wanted to see what would be the best way to handle this scenario. If I have a Cisco 2650 at our head end and a 1760 at our remote office doing a site to site vpn can I also set up a dynamic vpn for our remote vpn clients to also vpn in to t...

PIX 520 that is configured using CSPM seems to have reached it's maximum config size. When trying to make a config change through CSPM it says there is not enough space for request.When checking on the flash through the CLI....pp1# show flashfsflash ...

I have NAM-2(3.3.1 with patch 3.3.1)I just installed NAM in Cat6509. and then monitiring.I had configured SPAN(both and rx) to redirect whole traffic from cat6500 to NAM. At this time, I didn't configure about Valns. Because, i know the the NAM(3.3.1...

Is there any plan to incorporate any application layer inspection in the next PIX OS release?I don't mean more fixups for NAT, control/data channels etc. I mean for example, the capability to inspect http traffic.And speaking of the next release, C...

I have two pix 525's running 6.3(3). I failed over to the secondary and rebooted the primary.When the primary came back up its cpu is running close to 60%. "sh proc" shows the Pix Garbage Collector using alot of cpu time. Is this normalbehavior?pi...

HelloDoes anybody know, when PDM 4.0 will be available for the PIX 515E.Thank You

I have a PIX 515 and VPN client 4.01. When I use a dial up connection the tunnel works fine and I can see the internal network, but when trying to connect from another network (I suppose they have some firewall) or from my GSM phone (GPRS) the tunnel...

Is there any way to limit the bandwidth in Cisco PIX 515E?Regards

Hi,I'm using the Cisco VPN client 4.0.2 on windows XP and 2000 computers. I want to set the MTU to 1400. For that, i've used the "set mtu" cisco software. After my computer reboot, the mtu size is still 1300 bytes and my traffic is fragmented.Does an...

Is it possible?I have Ospf configurated with a router internet and I have second router that it isn´t running ospf on that.I have a static default route configured on second router with metric 120(upper than OSPF)The router configured with ospf is se...

Hi I am setting up a PIX515e firewall and cannot get it to work properly. We just want to start with a basic setup. The IP internal network is 172.18.1.xxx and the internet connection it though Verizon DSL and a small Netgear router. The router IP is...

Can you have two default routes with PIX 515? My goal is to be able to hook two interfaces to different routers. Each of the routers will be using BGP and they will serve as a redundant internet connection. This would require two pix interfaces an...

Has anyone got any news regarding the OS release 7 of PIX firewall? Any information as to what new features will support, what is the minimum requirements and when it would be available?

Hi... hopefully someone will be able to help a PIX newbie like me... here's the problem. I am moving from an ISA 2000 firewall server to a PIX 515E. Our network is on a 10.0.0.1 - 10.0.5.254 "network." I have two lines to the internet, however, which...