cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3927
Views
0
Helpful
2
Replies

Blocking out bound port 80 traffic using ASDM on ASA 5510

Dharmendra Sant
Level 1
Level 1

Hello,

   I am attempting to block outbound traffic for a specific PC on my LAN using the ASDM.. any advice is appreciated.

   Thanks.

2 Replies 2

grant.wilson
Level 1
Level 1

It is best to use the Cli.

access-list ACL deny tcp any any eq 80

access-group out interface outside

Grant

julomban
Level 3
Level 3

Dharmendra,

You need to block first the PC that you need to and then allow everyone else.

Example:

access-list outbound deny host 192.168.1.10 any eq 80

access-list outbound permit ip any any

Right after you create the ACL's you apply the rule into the inside interface or ourbound interface:

access-group outbound in interface inside

Regards,

Juan Lombana

Please rate helpful posts.

Review Cisco Networking for a $25 gift card