01-29-2019 09:40 PM - edited 02-21-2020 08:43 AM
I tried FTD and now I need revert ASA software with FirePOWER service.
ciscoasa# sh mod Mod Card Type Model Serial No. ---- -------------------------------------------- ------------------ ----------- 1 ASA 5506-X with FirePOWER services, 8GE, AC, ASA5506 JAD220000MS sfr Unknown N/A JAD220000MS Mod MAC Address Range Hw Version Fw Version Sw Version ---- --------------------------------- ------------ ------------ --------------- 1 28ac.9e75.f24c to 28ac.9e75.0000 2.0 1.1.8 9.8(2) sfr 28ac.9e75.f24b to 28ac.9e75.0000 N/A N/A Mod SSM Application Name Status SSM Application Version ---- ------------------------------ ---------------- -------------------------- Mod Status Data Plane Status Compatibility ---- ------------------ --------------------- ------------- 1 Up Sys Not Applicable sfr Recover Not Applicable
I flash asasfr according to this manual and it looks good
Judging by compatibility table I use correct versions ASA 9.8(2) and FirePOWER 6.2.2-81
asasfr-boot>system install ftp://192.168.1.1/incoming/asasfr-sys-6.2.2-81.pkg Verifying Downloading Extracting Package Detail Description: Cisco ASA-SFR 6.2.2-81 System Install Requires reboot: Yes Do you want to continue with upgrade? [y]: y Warning: Please do not interrupt the process or turn off the system. Doing so might leave system in unusable state. Upgrading Starting upgrade process ... Populating new system image Reboot is required to complete the upgrade. Press 'Enter' to reboot the system. Broadcast message from root (ttyS1) (Wed Jan 30 04:44:37 2019): The system is going down for reboot NOW! Console session with module sfr terminated.
ciscoasa#
But now sfr-module still in recovery mode as in "sh mod" from the first quote. I waited 30min and the module stays in recovery. If i try to reload or reset I have an error
ciscoasa# sw-module module sfr reload Reload module sfr? [confirm] Module sfr cannot be reloaded, not in Up state. ciscoasa# sw-module module sfr reset Module sfr should be shut down before resetting it or loss of configuration may occur. Reset module sfr? [confirm] Module sfr cannot be reset, please stop the current recovery before trying to reset the module.
Why? What do I do wrong?
Solved! Go to Solution.
01-29-2019 09:44 PM
01-29-2019 09:44 PM
01-29-2019 11:42 PM
Command debug module-boot helps me a lot. I have should wait more )
Big thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide