Can anybody tell me whether or not changing the standby ip of an interface on a Pix515e (7.2.2) will disrupt service or cause any problems?
interface Ethernet1
speed 100
duplex full
nameif inside
security-level 100
ip address 192.168.17.5 255.255.255.0 standby 192.168.17.3
pix515e#conf t
pix515e(config)#int e1
pix515e(config)#ip address 192.168.17.5 255.255.255.0 standby 192.168.17.6
Will this set of commands cause a service disruption?
Thanks