Changing the Standby IP on Pix515e 7.2

[thefindjack]

Can anybody tell me whether or not changing the standby ip of an interface on a Pix515e (7.2.2) will disrupt service or cause any problems?

interface Ethernet1
speed 100
duplex full
nameif inside
security-level 100
ip address 192.168.17.5 255.255.255.0 standby 192.168.17.3

pix515e#conf t

pix515e(config)#int e1

pix515e(config)#ip address 192.168.17.5 255.255.255.0 standby 192.168.17.6

Will this set of commands cause a service disruption?

Thanks

[thefindjack]

I found the answer...

Changing the Standby IP while in and Active/Standby Configuration (Primary is Active) does not disrupt network traffic.