cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

773
Views
0
Helpful
6
Replies
Highlighted

CISCA ASA VPN L2L UNSTABLE

Hi, I have a problem with a VPN L2L, initially I was using it to comunicate with  a remote client but last week a migrate the traffic to a dedicated channel, i just modified the route so the traffic right now is out for the dedicated channel but I let the the L2L VPN active. However I ckeked the VPN state and IT´S NOT ACTIVE, it´s keep jumping between states, one second is in state MM_WAIT_MSG3 and second later MM_WAIT_MSG3 and later is in Active.

Thanks for your answers.

Everyone's tags (4)
6 REPLIES 6
Highlighted

CISCA ASA VPN L2L UNSTABLE

Hello Javier,

As I understand you do not need to use the L2L tunnel any more right?

Why don't you eliminate the setup?

Hope I have understood the question!

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Highlighted

CISCA ASA VPN L2L UNSTABLE

Hello jcarvaja, like yolu said I don´t need the L2l but I would like to keep it active like a backup channel, the problem is the behavior of the VPN, why the behavior of the VPN?

Highlighted

CISCA ASA VPN L2L UNSTABLE

Hello Pedro,

Can you share the configuration of your ASA?

Regards,

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Highlighted
Mentor

Re: CISCA ASA VPN L2L UNSTABLE

Hi,

My guess would be that you are seeing the Phase1 negotiations go through as usually everyone has indentical Phase1 policys on their VPN equipment. So the Phase2 negotiations don't go through and I'd presume the remote end has deleted the actual L2L VPN configurations since you have dedicated connectection between you.

The remote end might have a network setup that doesnt permit having the L2L VPN configuration. In other words it might be that if the remote end had the L2L VPN configuration (including the Phase2 configurations), connections between your 2 LANs just wouldnt work as the routing would be asymmetrical (if thats even the word )

This could happen for example in a situation where the remote end has an ASA firewall and the new dedicated connection comes to the ASA on another interface. In other words the remote ASA can't have the L2L VPN configuration with your LAN network defined in both the L2L VPN and as a route towards the dedicated link.

- Jouni

Highlighted

CISCA ASA VPN L2L UNSTABLE

Hi Jouni, thaks for your answer but how I confirmed that? Which command can I use to confirm the intends of conection or how can I see the error of conection?

Highlighted

CISCA ASA VPN L2L UNSTABLE

Hi everyone I solved my problem, the L2L VPN was fine the problem is that not traffic it was been route for the VPN, I route part of the traffic for the VPN and it´s work fine. The state remain in active.

Thanks all for your answer.