Cisco 1120 FW using FMC 2500

[porkchopcb]

I have my 1120 FW added to the FMC 2500, and I have it mostly configured. When I go to edit the interfaces, I configured it and clicked on enable, but the interface is still not going green and when I ssh into the FW it says the ports are administratively shutdown. What am I doing wrong and how do I fix it? Thank you!

[Rob Ingram · Accepted solution]

@porkchopcb No changes are applied to the device until you deploy the changes, did you deploy the policy to the FTD? 

[porkchopcb]

Thank you! This is my first time using FMC. I'm an idiot and thought when you sync it, it was making the changes. I really appreciate it!