05-05-2015 03:31 AM - edited 03-11-2019 10:53 PM
We have purchased new cisco firewall 5525-X. As per Cisco we can configure multi context on firewall. But here we are using it as a standalone firewall. Can we configure firewall in ACTIVE/ACTIVE failover even if we configure it as a standalone firewall?
05-05-2015 05:17 AM
Hi,
No , this is not possible.
You can only configure Active/Active using two different ASA chassis and actually Active/Active also acts something close to Active/Standby using two different failover configured and they share the traffic on two chassis.
Thanks and Regards,
Vibhor Amrodia
05-05-2015 05:27 AM
Hello Vibhor,
We have two ASA firewalls, we are not using multi context but using single context. With this single context can we configure firewall in active/active failover?
Regards
Ashok
05-05-2015 05:30 AM
Hi,
No , you can only configure Active/Active HA using Multiple context on the way it works requires multiple context.
Thanks and Regards,
Vibhor Amrodia
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: