Hello everyone
I setup the ASA nice in my lab after i test the config for outside in (dhcp y static ip) but after I installed and configure with the public IP address I can't go outside or cominicate using inter vlan-routing but I can ping and access to the outside interface using my internet.
I have tried many thins on the forums and read a lot but i does no find the solution.
Maybe the problem is the licence because I have not trunk to make the L3 communication works and vlan1 and vlan 2 be able to communicate.
Waiting for your answers.
here the output from my pings
ping
Interface: inside
Target IP address: 10.0.0.1
Sending 5, 100-byte ICMP Echos to 10.0.0.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
ASA5505# ping
Interface: outside
Target IP address: 66.XX.XX.174
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 66.98.50.174, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
ASA5505# ping
Interface: inside
Target IP address: 66.98.50.174
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 66.98.50.174, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)
ASA5505# ping
Interface: outside
Target IP address: 10.0.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.1, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)
So inter-vlan routing is not wowrking after I have to use the followings commands to see if there any change but not results
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
policy-map global_policy
class inspection_default
inspect icmp
exit
exit
service-policy global_policy global
Here it is the output from the config.
ASA Version 8.2(5)
!
hostname ASA5505
enable password XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX encrypted
passwd XXXXXXXXXXXXXXXX.XXXXXXXXXXXXXXXXXXXXXXXXX encrypted
names
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 10.0.0.1 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 66.XX.XX.174 255.255.255.248
!
ftp mode passive
pager lines 24
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
global (outside) 10 interface
nat (inside) 10 10.0.0.0 255.255.255.0
route outside 0.0.0.0 0.0.0.0 66.XX.XX.169 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
aaa authentication ssh console LOCAL
aaa authentication http console LOCAL
http server enable
http 0.0.0.0 0.0.0.0 outside
http 10.0.0.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
telnet timeout 5
ssh 10.0.0.0 255.255.255.0 inside
ssh 0.0.0.0 0.0.0.0 outside
ssh timeout 5
console timeout 0
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
username XXXX password XXXXXXXXXX encrypted privilege 15
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect ip-options
inspect netbios
inspect rsh
inspect rtsp
inspect skinny
inspect esmtp
inspect sqlnet
inspect sunrpc
inspect tftp
inspect sip
inspect xdmcp
!
service-policy global_policy global
prompt hostname context
no call-home reporting anonymous
call-home
profile CiscoTAC-1
no active
destination address http https://tools.cisco.com/its/service/oddce/services/DDCEService
destination address email callhome@cisco.com
destination transport-method http
subscribe-to-alert-group diagnostic
subscribe-to-alert-group environment
subscribe-to-alert-group inventory periodic monthly
subscribe-to-alert-group configuration periodic monthly
subscribe-to-alert-group telemetry periodic daily
Cryptochecksum:0c8a226f7c4a8d5a03e6fcd821893898
: end
