cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
895
Views
0
Helpful
3
Replies

Cisco ASA 5505 KO after upgrade

Hello,

I upgraded cisco asa image to 8.4.2  coming form a 7.x image.

after copying with tftp and after

boot system image disk0:/asa842-k8.bin

the system rebooted after a manual reload and now there is a christmas tree...

as soon as I plug the power coord the status led is amber and all the interfaces green led

aref lashing at the same time....

any hints ?

thank you very much

Rick

1 Accepted Solution

Accepted Solutions

Anu M Chacko
Cisco Employee
Cisco Employee

Hi Riccardo,

Could you leave the ASA powered down for a minute or 2 and then see if you face the same issue?

Let me know.

Regards,

Anu

View solution in original post

3 Replies 3

Anu M Chacko
Cisco Employee
Cisco Employee

Hi Riccardo,

Could you leave the ASA powered down for a minute or 2 and then see if you face the same issue?

Let me know.

Regards,

Anu

After waiting for 15 minutes the ASA comes up woth no problem... looks like an overheat problem,

but the strange thing is that it rised upon reboot after a asa system image upgrade...

fortunately it did not happen again but right now I am using the ASA really with reduced network traffic,

so it is not loaded at all...

thank you!

Rick

Hi Rick,

That's good.

Regards,

Anu

P.S. Please mark this question as answered if it has been resolved. Do rate helpful posts!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card