09-12-2016 02:30 PM - edited 03-12-2019 01:15 AM
Hi People,
I have a quick question, I'm trying to migrate a config file from a ASA 5540 to a 5555X.
The 5540 config is on version 9.1 and I'd like to migrate to 9.6
I've researched that it's a direct upgrade but are there any CLI changes from 9.6 to 9.1 that I should be concerned when using the same config file?
I look forward to your reply.
Thanks in advanced
Sincerely,
Dante V.
Solved! Go to Solution.
09-12-2016 03:16 PM
Hi Dante,
You can check the release note of 9.6 and see if there is any reported syntax change, if not you can still keep a copy of you old configuration and check something changed after the upgrade.
Hope this info helps!!
Rate if helps you!!
-JP-
09-12-2016 02:45 PM
Hi Dante,
There are not considerable syntax changes between those version, you should be able to migrate the config files without any problem.
Hope this info helps!!
Rate if helps you!!
-JP-
09-12-2016 02:52 PM
Thanks for the reply JP.
Where in the config can I expect to see some syntax changes (if any)?
Just so that I'm prepare to research for the appropiate syntax.
09-12-2016 03:16 PM
Hi Dante,
You can check the release note of 9.6 and see if there is any reported syntax change, if not you can still keep a copy of you old configuration and check something changed after the upgrade.
Hope this info helps!!
Rate if helps you!!
-JP-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide