cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1980
Views
10
Helpful
5
Replies
Highlighted
Beginner

Cisco Firepower 4120 enable hardware bypass

hi

i am configuring my Cisco Firepower 4120 appliance.

it has the 6 port FTW module.

in the GUI, i see bypass state enabled for ports 3-4

but it says disabled for ports 1-2 and 5-6 and i dont see an option anywhere to enable it.

where is the option to enable it ?

the license has yet to be applied (waiting on my reseller for it). is that the reason the other ports are showing bypass disabled ?

5 REPLIES 5
Highlighted
Rising star

The FTW network modules have built-in SFPs.

Hardware bypass is supported only on a fixed set of ports. You can pair Port 1 with Port 2, Port 3 with Port 4, but you cannot pair Port 1 with Port 4 for example.

For more info see the below link

http://www.cisco.com/c/en/us/td/docs/security/firepower/4100/hw/guide/b_install_guide_4100/b_install_guide_4100_chapter_01.html#id_21777

Hope this help you

Highlighted

it does not.

i know how the pairings work. my question was i just see 1 pair enabled and the other 2 disabled. where can i find the option to enable the other 2 pairs

Highlighted

Hi Tejas, I have the same problem, could you solve it?

Highlighted

Hi Julio,

 

FYI

 

Captura.JPG

Highlighted

Thanks Manuel! Regards from GT.

Content for Community-Ad