02-08-2017 07:08 AM - edited 03-10-2019 06:46 AM
hi
i am configuring my Cisco Firepower 4120 appliance.
it has the 6 port FTW module.
in the GUI, i see bypass state enabled for ports 3-4
but it says disabled for ports 1-2 and 5-6 and i dont see an option anywhere to enable it.
where is the option to enable it ?
the license has yet to be applied (waiting on my reseller for it). is that the reason the other ports are showing bypass disabled ?
02-08-2017 09:47 AM
The FTW network modules have built-in SFPs.
Hardware bypass is supported only on a fixed set of ports. You can pair Port 1 with Port 2, Port 3 with Port 4, but you cannot pair Port 1 with Port 4 for example.
For more info see the below link
Hope this help you
02-08-2017 10:28 AM
it does not.
i know how the pairings work. my question was i just see 1 pair enabled and the other 2 disabled. where can i find the option to enable the other 2 pairs
07-29-2019 02:15 PM
Hi Tejas, I have the same problem, could you solve it?
08-06-2019 09:16 AM
Hi Julio,
FYI
08-06-2019 09:53 AM
Thanks Manuel! Regards from GT.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: