am using FBR 1010 to Configure AnyConnect Remote Access, on my test lap i used 192.168.1.0/24 as outside, and 126.96.36.199/24 as Inside, FW IP is 188.8.131.52 and outside VPN IP is 192.168.1.111
i connected VPN Client and i can access internet but i can not ping or https://184.108.40.206, any Help???
You rule should ressemble something like this:-
AND you need to ensure this NAT exemption rule is above your current rule #1, as at the moment your traffic from inside_2 will be natted on the outside interface.
Provide the output of "show vpn-sessiondb detail anyconnect" and "show nat detail"
EDIT: You Firewall rule above doesn't permit trafic from outside to inside. All RAVPN traffic is sourced from outside, so you need to explictly permit traffic to inside.
You needed to update your FIREWALL rule in the Access Control Policy, not the nat rule. The NAT rule you had previously would have sufficed, you need to change it back. When configured correctly the output of the NAT Exemption rule from the CLI would look like this:
"nat (inside_2,outside) source static InsideNetwork InsideNetwork destination static VPNPool VPNPool no-proxy-arp" - ensure it's the top nat rule.
InsideNetwork = inside_2 interface and VPNPool = outside interface, you need to ensure the nat rules are firewall rules reflect the correct source/destination interface.
Change your NAT rule back and amend the firewall rule, permitting traffic between the VPNPool and InsideNetwork and another permitting traffic from InsideNetwork to VPNPool.