03-07-2021 01:40 PM
Hello Guys,
Today we just experienced an ambiguous behavior. We've a Cisco IPS 7120 sensor from the old days just after rebooting, it freezed that is, all interfaces are up, ping is working fine from the sensor to FMC and vice versa but can't apply any change. Also when logging via CLI and issue "show manager" it said no managers configured and any show command displays a blank output however, before the reload we checked all show commands and all outputs were correct.
Any ideas on what went wrong during the reload?
Thanks everyone.
Solved! Go to Solution.
03-09-2021 06:53 AM - edited 03-09-2021 07:47 AM
Since if you decided to re-image
try below command
sudo su
/etc/rc.d/init.d/mysqld status
/etc/rc.d/init.d/mysqld restart
check the logs
If this device managed by FMC. FMC should have all the information, check if you can take any local backup and settings
sure re-image should work, since do you do not have contract to open a TAC case.
03-11-2021 05:54 AM
Hi balaji,
I managed to fix the issue by Re-Imaging the device. One thing that was a nightmare is that the interactive menu couldn't found the ISO image on FTP / SCP.
Finally solve it by using HTTP server.
Revert to the base image then register with FMC and patch update sequentially.
Thanks ☺️☺️☺️
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide