command for Cisco ASA5516-X firepower

[jona_board]

Hello,

Well I have this firewall Cisco ASA5516-X firepower with this default configuration:

timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 sctp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00

I want to edit this configuration on CLI.

please.

regards

[Karsten Iwen]

what and why do you change this configuration? Very often the defaults are absolutely ok. If you change them you exactly should know what you want to achieve.

You can change them with the "timeout ..." command.

[jona_board]

I need to edit that configuration because the server keep session for more than 1 hour.

I think I need to configurate by expert mode.

[Mohammed al Baqari]

Is it running FTD? If yes you can configured from GUI not from CLI.

[jona_board]

that configuration not appear, I have FTD without management center

[Mohammed al Baqari]

You can use FDM which was introduced in 6.2 if I recall

[jona_board]

In GUI that kind of configuration it doesn't exist. I find another mode with "system support diagnostic-cli ".

after that I put "enable" but I don't really sure if I can use "configure terminal" that command doesn't appear.