cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
312
Views
0
Helpful
1
Replies

Config change should be seen at Radius

interfacedy
Participant
Participant

Hi, When some config change was made at switch or router, if we want to see the change record, where should we see? in Radius or TACACS ISE? Second question: If just typing command with saving or without saving config, what difference of the two we can see in Radius or TACACS? Thank you

1 Reply 1

Rob Ingram
VIP Expert VIP Expert
VIP Expert

@interfacedy you would need to use TACACS in order to determine the commands used configuring the switch/router. RADIUS will not provide this information.

 

If you type the command and don't press enter, nothing is sent to ISE, but if you press enter each command is authorised by TACACS independently. It doesn't matter about saving or not, if you are not authorised by the TACACS server to enter the command you will not be allowed.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers