cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
286
Views
10
Helpful
3
Replies

Configure Failover on ASA 5505 with different RAM

chhayheng
Level 1
Level 1

Dear Expert,

Can I configure Failover on ASA 5505 with different RAM:
ASA-1 = 512MB
ASA-2 = 256MB

Beside of that problem is correctly.

Best Regards,
Chhayheng

3 Replies 3

Having different amounts of RAM on both ASAs is not supported. This is from the config-guide:

Hardware Requirements 

The two units in a failover configuration must be the same model, have the same number and types of interfaces, and the same SSMs installed (if any). Both units must have the same amount of RAM memory installed.

I think so. Some of them said and advice me to take a higher RAM size is active and Lower size is standby. That why I wonder.
Do you have any idea ?

Best Regards,
Chhayheng

> Do you have any idea ?
 

Only to upgrade ASA2 to 512 MB.

Review Cisco Networking for a $25 gift card