Configuring ASA 5510 w/ SSM-10 in transparent mode
I'm trying to configure an ASA5510 w/ SSM-10 to run in transparent mode and be able to manage it remotely. This setup is due to the client's environment. I'm familiar with 5505's, but this is the first time with a dedicated management port and a dedicated IPS Ethernet port.
- Can I access both the FW and IPS through the dedicated management port via SSH and ASDM/IDM?
- Can I assign the management port an external IP address and to establish a L2L VPN tunnel for remote management and tunnel syslog and IPS logs through it?
- Would I be able to route Syslog and IPS event through the Management port to a remote event collector?
- Cabling clarification: internal switch connected to the ASA's management interface and to the IPS' management interface.
You would like to use the ASA Firewall Umbrella Connector to enforce DNS policy with Umbrella. However you would also like to exclude certain IP addresses or subnets from using this policy. I recently had the need to do this, had a bit of tro...
Hi Everyonem Just wondering if anyone knows why I am getting an error that says "Cryptographic algorithms required by the secure gateway do not match those supported by AnyConnect. Please contact your network administrator.". See attached...
The Cisco 2020 CISO Benchmark Report provides valuable takeaways and data on the most pressing topics: the impact of vendor consolidation, cybersecurity fatigue, outsourcing, top causes of downtime, the most impactful threats, and more. The repo...
Hi, Has anyone run into the "Channel down" issue when updating the identity certificate on the Stealthwatch SMCv and SFCv. I'm doing a POC for a client and every time I go an update the identity cert the SMC says "it could save the configuration" and...
On July 16 2020, the U.K. National Cyber Security Centre and Canada’s Communication Security Establishment, in cooperation with the U.S. National Security Agency and Cybersecurity and Infrastructure Security agency, issued an advisory [...