Configuring SNMP Traps for Cisco FMC

[renzanjo-caparas]

Hi everyone!

I was able to configure the SNMP port 161 on the FMC via GUI. But I cannot seem to find the SNMP Traps configuration. 

Below I managed to check in FMC CLI , but I am stuck on how I will implement them and make my FMC send traps to our SNMP Manager.
IF-MIB::ifNumber.0 = INTEGER: 2
IF-MIB::ifIndex.1 = INTEGER: 1
IF-MIB::ifIndex.2 = INTEGER: 2
IF-MIB::ifDescr.1 = STRING: lo
IF-MIB::ifDescr.2 = STRING: Microsoft Corporation Device 0003
IF-MIB::ifType.1 = INTEGER: softwareLoopback(24)
IF-MIB::ifType.2 = INTEGER: ethernetCsmacd(6)
IF-MIB::ifMtu.1 = INTEGER: 65536
IF-MIB::ifMtu.2 = INTEGER: 1500...etc.

MAy I ask for further advise?

Regards,
Renz

[Mark Elsen]

  - @renzanjo-caparas              FYI : Configure FXOS SNMPv1/v2c in the GUI

  M.

[renzanjo-caparas]

Hi @Mark Elsen ,

Apologies but isn't this the settings for the managed devices of the FMC? I am seeing the same settings in my FMC but it's the platform settings for the managed devices.

Regards,
Renz 

[Mark Elsen]

  - @renzanjo-caparas     Go to  System → Configuration → SNMP    , enable snmp  , you should be
                                        able to specify a trap destination in one of the menu's

  M.

[balaji.bandi]

Device --Platform settings, select the device and below option for Traps