Deploy ASA High Availability in FirePower 4112

[Arie --]

Hi,

I want to deploy ASA with HA Active/Passive in FirePower 4112.

When deploy the ASA instance in FirePower, do I need to select 'Cluster' as device mode? Or just select standalone and then configure the HA in the ASA CLI?

Thanks

Arie

[MHM Cisco World]

Configure FTD High Availability on Firepower Appliances - Cisco

check this guide

[Arie --]

Hi,

Does the guide also applicable for ASA image?

Thanks

[Marius Gunnerud · Accepted solution]

For active passive you want to select standalone and then configure HA failover.  Clustering something different where traffic is load-balanced between the ASAs in the cluster.

[Arie --]

Hi,

Oh I see, so I don't need to configure cluster in FMC for ASA image, just configure usual HA failover in ASA CLI, is it correct?

Thank you

[Marius Gunnerud]

correct