cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
865
Views
0
Helpful
2
Replies

DMVPN NHRP issue

ricey
Level 1
Level 1

I have a phase 2 DMVPN network with approx 40 spoke routers and dual hub routers. 90% of this is working very well. However I have 3 or 4 spoke routers that are unable to communicate with each other directly (traffic goes via the hub router between these specific sites) however they are able to coomunicate directly with the other 35 or so routers. I think this is an NHRP issue as when I do show ip nhrp detail on one of these 4 routers, the other 3 routers display a (no socket) entry. I am able to clear this "sometimes" by clear ip nhrp. Whenever the (no scoket) entry is there spoke to spoke communication does not work. Any help would be greatly appreciated.

1 Accepted Solution

Accepted Solutions

pradeepde
Level 5
Level 5

Have you checked this bug CSCsw18019

TEA spoke-spoke communication going thru hub if nhrp cache non-author.

View solution in original post

2 Replies 2

pradeepde
Level 5
Level 5

Have you checked this bug CSCsw18019

TEA spoke-spoke communication going thru hub if nhrp cache non-author.

pradeepde,

Thank you very much for your response. I think you may be right, I have upgraded the IOS to a maintenance release 12.4.15T9 and this does appear to have fixed the problem.

Thanks again

Review Cisco Networking for a $25 gift card