Dynamic DNS Client in FTD

[frederico.miyamoto]

Hi Everyone!

I have an FTD 1010 managed by FMC, and I would like to configure a Dyndns client on it, since one of the interfaces of my ISP is DHCP, all the documentation I found so far is the creation of the internal DDNS. Would anyone know how to proceed?

[Chakshu Piplani]

Hi,

I did some digging about your request and found this doc (link below), not sure if this is what you are looking for:

https://www.cisco.com/c/en/us/td/docs/security/firepower/640/configuration/guide/fpmc-config-guide-v64/dhcp_and_ddns_services_for_firepower_threat_defense.html

HTH

Regards,

Chakshu

Do rate helpful posts.

[frederico.miyamoto]

Hello @Chakshu Piplani!

Thanks for your reply!

I believe that this configuration is for my LAN, I needed to configure it for my ISP, configure a ddns client as a dyndns or noip for example, is there a possibility of this configuration?