factory default config on ASA5505 with 8.4.1

[plao]

What is the factory default config on ASA5505 with 8.4.1? Thanks!

[plao]

sorry never mind...I found it in the ASDM config guide now

http://www.cisco.com/en/US/docs/security/asa/asa84/asdm64/configuration_guide/intro_start.html#wp1186145

[plao]

Can someone confirm this is the whole factory def config? It does not show the default global inspection policy?

thanks

The configuration consists of the following commands:

interface Ethernet 0/0

   switchport access vlan 2

   no shutdown

interface Ethernet 0/1

   switchport access vlan 1

   no shutdown

interface Ethernet 0/2

   switchport access vlan 1

   no shutdown

interface Ethernet 0/3

   switchport access vlan 1

   no shutdown

interface Ethernet 0/4

   switchport access vlan 1

   no shutdown

interface Ethernet 0/5

   switchport access vlan 1

   no shutdown

interface Ethernet 0/6

   switchport access vlan 1

   no shutdown

interface Ethernet 0/7

   switchport access vlan 1

   no shutdown

interface vlan2

   nameif outside

   no shutdown

   ip address dhcp setroute

interface vlan1

   nameif inside

   ip address 192.168.1.1 255.255.255.0

   security-level 100

   no shutdown

object network obj_any

   subnet 0 0

   nat (inside,outside) dynamic interface

http server enable

http 192.168.1.0 255.255.255.0 inside

dhcpd address 192.168.1.2-192.168.1.254 inside

dhcpd auto_config outside

dhcpd enable inside

logging asdm informational

[Maykol Rojas · Accepted solution]

Hi,

It should be part of the configuration, if it does not appear, you can bring it back using the command:

clear config fixup

That would bring back the default global policy.

Cheers.

Mike