Hi all ,
I have two 6500 on VSS mode and they have Firewall Service Module (WS-SVC-FWM-1) each.
These FWSMs is running Active/Active as failover state.
When I configure the 1st one and run write mem command , the ipv6 config on 1st one not syncronized with 2nd one. But another all config except ipv6 is sync with 2nd one.
Is this a bug ? What do you suggest about this issue ?
Thanks for your support.
# sh ver
FWSM Firewall Version 4.1(7)
Device Manager Version 6.2(2)F
Compiled on Wed 07-Sep-11 13:35 by fwsmbld
up 1 day 21 hours
up 121 days 14 hours
Hardware: WS-SVC-FWM-1, 1024 MB RAM, CPU Pentium III 1000 MHz
Flash STI Flash 8.0.0 @ 0xc321, 20MB
0: Int: GigabitEthernet0 : address is 0022.5528.6480, irq 5
1: Int: GigabitEthernet1 : address is 0022.5528.6480, irq 7
2: Int: EOBC0 : address is 0000.1900.0000, irq 11
The Running Activation Key is not set, using default settings:
Licensed features for this platform:
Maximum Interfaces : 256
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Cut-through Proxy : Enabled
Guards : Enabled
URL Filtering : Enabled
Security Contexts : 2
GTP/GPRS : Disabled
BGP Stub : Disabled
Service Acceleration : Disabled
VPN Peers : Unlimited
-------------------------------
NAME: "Chassis 1 9", DESCR: "Chassis 1 WS-SVC-FWM-1 6 ports Firewall Module Rev. 4.5"
PID: WS-SVC-FWM-1 ,
NAME: "Chassis 2 9", DESCR: "Chassis 2 WS-SVC-FWM-1 6 ports Firewall Module Rev. 4.5"
PID: WS-SVC-FWM-1 ,
