cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
365
Views
0
Helpful
2
Replies

Failover setting on ASA with CSC module

Hi there ... I'm a single ASA-5510 with CSC module ... I want to pair it for active/standby mode for failover .... can it be done if second ASA doesn't have the module? Can I assume the in case of a failover, the traffic won't be checked, and primary does in case CSC module fails?

Thanks                  

2 Replies 2

Julio Carvajal
VIP Alumni
VIP Alumni

can it be done if second ASA doesn't have the module?

No, exact hardware must be used.

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

lcambron
Level 3
Level 3

Hello Gustavo,

You can remove the module from the primary ASA, and setup failover with no CSC at all, but as Julio stated the hardware must be the same.

Regards,

Felipe.

Review Cisco Networking for a $25 gift card