cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

527
Views
0
Helpful
0
Replies
Highlighted
Beginner

Failover Stateful link problem

Hi all,

i use subinterfaces using vlan 1 and 2 for failover and stateful links prior to failover configuration in ASA5520. when i write "failover" command in standby unit it clears the stateful link configuration on standby unit giving an error. replication is performed, eveything is normal when you look at failover condition on the primary unit. however, stateful failover does not work since no link exists between units.

what can i do?

0 REPLIES 0
Content for Community-Ad