cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
516
Views
2
Helpful
6
Replies

Firepower 1010 cannot access web GUI

dbronco
Level 1
Level 1

I am having some trouble with a new Firepower 1010 that was delivered with 7.2.5 running on it. I was having a few problems with a port not passing traffic when set to auto-negotiate, but we defaulted the device as a troubleshooting step and can now no longer access the web GUI. 

I've followed this https://community.cisco.com.mcas-gov.us/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589 without success. 

I ran through the running-config and the only noticeable difference I can see is 'http server enable' missing - as seen from a known good device. I've searched multiple sites and cannot figure out how to enable that, or if that is truly the problem. I've attached a screenshot of the error we're seeing and the CLI output. 

Thank you for the help

1 Accepted Solution

Accepted Solutions

dbronco
Level 1
Level 1

Even though the device was set to be managed locally, this was the ultimate fix

configure manager delete

configure manager local

Thank you all for the help

View solution in original post

6 Replies 6

marce1000
VIP
VIP

 

  - Could you add those directives from 'working appliance.txt' too in the running configuration of the
  problematic firepower device(?)

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

I did try that but they don't seem to be valid commands. I haven't been able to question mark my way through it yet, do you know how to do this? 

Manage the device locally? (yes/no) [yes]: Yes 

did you select device mgmt locally ?
MHM 

Yep, I followed your directions from another post to make sure everything was set correctly. 

Gopinath_Pigili
Spotlight
Spotlight

Hello dbronco,

Please follow the link..you can find similar kind of discussion....

https://community.cisco.com/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589

Best regards
******* If This Helps, Please Rate *******

dbronco
Level 1
Level 1

Even though the device was set to be managed locally, this was the ultimate fix

configure manager delete

configure manager local

Thank you all for the help

Review Cisco Networking for a $25 gift card