Firepower 1120 adds static route through CLI

[NeilL391]

Hi guys,

Would like to ask how to configure the static route through CLI on firepower 1120? I connected into FTD and tried to add static route but it shown only for MGMT interface, how to configure it on outside interface? (Through the DR test, we cant connect FMC, so we have to log into firepower through CLI and do config). Thx a lot!

Neil

[MHM Cisco World · Accepted solution]

It true cli static route is only for mgmt.

Check this link maybe it can help you

https://www.petenetlive.com/KB/Article/0001172?amp=1

MHM

[NeilL391]

Hi MHM，

Thx a lot!

Best regards,

Neil

[Rob Ingram]

@NeilL391 as of the current version you cannot configure a static route via the data interfaces from the CLI (you can with the mgmt interface), I believe configuring some functions via the CLI is coming in future releases.

[NeilL391 · Accepted solution]

Hi rob,

Thx for the reply!

Best regards,

Neil