firepower 1140 PLR license

[MrBeginner]

Hi,

I would like to ask about PLR for firepower. My firepower don't have internet so i run with evaluation license.Now I want to change to PLR.

I knew how to switch to PLR from registered the device using smart licensing.

But i cannot find how to switch eva license to PLR for firepower ?

Please let me know how to generate Reservation Request Code in evaluation license applied device ?

[Francesco Molino]

Hi

Is this for FDM or FMC?

FMC supports classic license by going through option (wheel menu on top right), then licenses and classic licenses.

On FDM, you only have smart licenses:

https://www.cisco.com/c/en/us/td/docs/security/firepower/roadmap/firepower-licenseroadmap.html

[MrBeginner]

Hi ,

I am using FDM. So i am using smart license. But our DC don't have internet .So i cannot use Direct Cloud Access method. I want to use Full Offline Access. But I am not sure Firepower 1000 support this function. I found below reference guide in cisco website.

https://www.cisco.com/c/en/us/td/docs/security/firepower/660/fdm/fptd-fdm-config-guide-660/fptd-fdm-license.html#id_123881
 As per above link ,cisco said to do like below but i didn't see PLR option on my device setting. I only see resnyc and unregister option only. is it because of firmware version ? My firmware is 6.4. Or do FDM only support direct cloud access ?

[Francesco Molino]

Sorry for my late answer.

Give me some time, I will try to deploy a FTDv tomorrow and look at it. Never tried PLR before.

I’m going to come back to you asap this week.

[Francesco Molino · Accepted solution]

Ok tested and I have the option on an FTDv. You are in evaluation mode right?

[UCrypto]

Hi,

How to generate Reservation request code from FDM ?

[mcaroffi]

How to switch from Smart License to a Permanent license. 

Activating PLR License on Cisco FMC - Cisco License