cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1696
Views
0
Helpful
6
Replies

Firepower 2110 PPPOE

sxzhang23300
Level 1
Level 1

Firepower 2110 only has interface type static and dhcp.I cannot see pppoe option in WAN interface.

I use FDM for management. 

6 Replies 6

Marvin Rhoads
Hall of Fame
Hall of Fame

As noted below, FDM-managed Firepower Threat Defense hardware appliances added PPoE support in 6.6.

PPPoE is not supported on FMC-managed devices. If your ISP requires PPPoE, you will have to put a router with PPPoE support between the FTD and the WAN modem (when using FMC management).

 

ok

Then I have only two methods now.

1.put a router with PPPoE support between the FTD and the WAN modem.
2. Can it be achieved by downgrading the version?

Thanks for the update @Rob Ingram. I had forgotten they added that to FDM only in 6.6.

I corrected my earlier reply.

Okay, thank you. I saw. The current version of the customer is 6.2.3

When you configure/edit the physical interface, for IPv4 for example, under IPv4 choose "PPPoE" and you should see the authentication parameters, see attached:

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: