cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

768
Views
4
Helpful
3
Replies

Firepower not able to send traffic in Virtual routed mode

Hello,

I have installed SourceFire 7215 in my org and deployed FireSIGHT mgmt Center Virtual Appliance. i have added phy appliance to fireSight manager & installed required licenses. we have procured, control, protection & Malware license. I am currently using 6.0.0 version on physical appliance 7125 as well as on FireSight Virtual appliance.

Since this device is placed in internet EDGE. we are looking to deploy in routed mode, however my problem is i am not able to route traffic from INSIDE to OUTSIDE. i have created Virtual router and assigned to phy interface, in addition, created access policy to allow inside traffic to outside which is connected to SP.

i am not able to find appropriate doc, hence request you to help on the above issue.

3 REPLIES 3
Troy Jackson
Beginner

I found this guide to useful in all of my SourceFire deployments. It's a few versions behind but it covers the 3D models and Cisco senors as well. 

http://www.cisco.com/c/dam/en/us/td/docs/security/sourcefire/3d-system/53/Sourcefire_3D_System_User_Guide_v53.pdf

Please remember to rate useful posts, by clicking on the star below.
-Troy J.

Thanks Troy for the sharing wonderful document.

Issue resolved!!! 

Sunil Kumar
Cisco Employee

Have you configured the routing and NAT policy to route the inside network traffic? Below link will help you to accomplish this. 

http://www.cisco.com/c/en/us/td/docs/security/firesight/541/user-guide/FireSIGHT-System-UserGuide-v5401/Virtual-Routers.html#pgfId-7192364 

http://www.cisco.com/c/en/us/td/docs/security/firesight/541/user-guide/FireSIGHT-System-UserGuide-v5401/NAT-Policies.html 

Create
Recognize Your Peers
Polls
Which of these topics should we host an event in the Community?

Top Choice: ISE- Guest and Posture Troubleshooting (50%)

Content for Community-Ad