cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

339
Views
0
Helpful
3
Replies
Highlighted

firepower security engine TACACS+ Authentication

Hi team,

 

I have configured Cisco ISE as TACAC+ for firepower chassis. i am able to authenticate chassis with TACACS+ credentials.

But when i tried to login security engine which is not authenticating with TACACS+ but i can login using chassis local user accounts.

 

Looking for solutions to make security engine to authenticate with TACACS+.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Guru

If the security engine is running Firepower Threat Defense (FTD) image, TACACS+ is not supported.

If it's running ASA software then it's just like a normal ASA with respect to TACACS+ (fully supported).

View solution in original post

3 REPLIES 3
Highlighted
VIP Mentor

@VishnuvardhanaRR06192 

You can configure the FXOS chassis (FCM) to use TACACS+ authentication, but the FMC does not support TACACS for user authentication. It does support RADIUS and you can create user roles to assign different privileges.

 

Here is a guide:-

https://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118541-configure-firesight-00.html

Highlighted

Hi,

 

My question is that how to make Security Engine (Logical Device security module) to authenticate with TACACS+ ISE.

Highlighted
Hall of Fame Guru

If the security engine is running Firepower Threat Defense (FTD) image, TACACS+ is not supported.

If it's running ASA software then it's just like a normal ASA with respect to TACACS+ (fully supported).

View solution in original post

Content for Community-Ad