FMC 6.4.0.8 Prefilter Rule available port still in loading state

ssambourg · ‎03-04-2020

Hello,

We upgraded FMC from 6.2.3 to 6.4.0.8.

After this upgrade, we started to create prefilter rule (no one prefilter rule before).

Under 'Port' tab, the available port section stays in Loading state.

I don't see this behavior under ACP rules.

Anyone note that ? I look after a way to troubleshoot that in CLI.

I've attached a screenshot of the concerned tab.

balaji.bandi · ‎03-04-2020

I have not noticed that behaviour before, reboot the FMC and check.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

ssambourg · ‎03-05-2020

Hello,

Unfortunately after FMC reboot I still have the problem.

We also try with different browser (chrome, Edge, FF).

Felipe Cavalcante · ‎08-20-2020

Hello everyone!

I'm with the same problem on FMC version 6.4.0.4. On the Prefilter policy under "Port" tab, the information still in loading state. Is there any reason for this? Could be a possible bug?