cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5079
Views
5
Helpful
5
Replies

FMC not showing events

hashimwajid1
Level 3
Level 3

Hi Experts 

I've deployed 2 x ASA 5525x in HA. both devices have added in FMC. i can see that traffic is passing through the SFR module by using sh service policy command. but  vFMC is not showing any event on dash board.

- i've created a basic policy on FMC and pushed it toward firewalls.

- logs are enable in policy

- i am using vFMC 6.2.1/ SFR 6.2.0/ IOS 9.6.3 image 

Regards

 

5 Replies 5

Marvin Rhoads
Hall of Fame
Hall of Fame

Can you share a screen shot of your Access Control Policy with logging enabled?

Make sure to follow below path :

on the main page >> Analysis >> Connections >> Events 

Ensure Firewall is having traffic going through it, show conn would help 

Muhammad Azhar
Level 1
Level 1

 

 

Please enable logging in access control policy , i test it on FMCv 6.2.3.

 

You may also check if Time is sync/same in both FTD and FMC. 

Once common problem in eventing is, FTD sends event with different time stamp and FMC has different time, resulting no even shown up in FMC on expected time window.   

You may also check if Time is sync/same in both FTD and FMC. 

Once common problem in eventing is, FTD sends event with different time stamp and FMC has different time, resulting no even shown up in FMC on expected time window. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: