cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4259
Views
10
Helpful
2
Replies

FMC Reports - "Failed to Generate"

Worked fine in version 6.1.0.4-17, but then,

After upgrading sensors and threat defense center to 6.1.0.5-45,

Custom and built in reports fail with "Failed to generate".

Regardless of output type, html, pdf, csv.

I even created new templates, same issue.

Is anybody else having this issue, or where to review the debug output for the cause?

I'd sure like to rate this release over on the support download site.

Thanks -

Active/Standby pair ASA-5545X 9.6(2) with Firepower services, virtual.

Sensors 6.1.0.5-45

Defense center 6.1.0.5-45. 

 

off topic and also broken in this release:

'Remove all completed tasks' in FMC task dropdown.

 

1 Accepted Solution

Accepted Solutions

Known issue.  workaround for bug CSCve70800

 

Prebuilt reports fail to generate immediately due to DiskManager handling of drains
CSCve70800
 
(cco login required)
 

View solution in original post

2 Replies 2

Known issue.  workaround for bug CSCve70800

 

Prebuilt reports fail to generate immediately due to DiskManager handling of drains
CSCve70800
 
(cco login required)
 

I am facing a similar issue with FMC 6.4 however the report generation is failing only for  Network Risk type. Any idea?

Review Cisco Networking for a $25 gift card