Forcefully Sync configure in FTD HA

[NeWGuy1109]

I have an FTD HA cluster which is added in Algosec for Optimization... recently i noticed that the object count and service count statistics are different for different members as shown in Algosec Config.

Is there a way to verify this from Firewalls ? and how can i forcefully sync config for an FTD HA ?

[Lixia Li]

Hi, @NeWGuy1109 

Not quite sure how Algosec display the different count statistics, but if you want to check the count statistics for FTD HA, you could go to FMC>Objects>Object Management, for instance in Network tab, it shows all Network Objects and in the bottom you could see the total Object count, you can also check “show unused objects” checkbox and calculate the total used object count for FTD. Since FTD HA is using same policy, so the object count for each device should be same. 

If you need further assistant on troubleshooting the issue, please contact Cisco TAC for support.