07-25-2018 07:57 AM - edited 03-12-2019 06:50 AM
Hi,
Is it possible to configure changes in the ASA CLI of the ASA-FTD?
Thanks
07-25-2018 08:17 AM
Hi,
On the FTD you can change some system settings (management ip, dns etc), but on the LINA (ASA) you can do only troubleshooting commands (show, debug, packet-tracer etc.
07-25-2018 09:03 AM
To add to Rodrigo's comment, there are some settings that are not in the GUI but you can push ASA style commands to LINA using FlexConfig. Here is a sample use case: https://hacksbrain.com/2018/07/24/firepower-flexconfig-a-practical-example/
07-25-2018 09:11 AM
Hi aaron,
but what if I don't use flex-config just configure what i need straight ahead in the CLI, is that possible?
thanks
07-25-2018 09:54 AM
Hello,
If you are running ASA code, then the ASA CLI is available. If you are running Firepower Threat Defense (FTD) Nextgen Firewall, then, no you cannot make changes on the CLI save a few things to make the box remote manageable. You must either use FDM, FMC, or APIs provided by FDM or FMC.
There is no "conf t".
-A
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: