07-06-2020 05:19 PM
Hi Guys,
I am trying to configure a Fiber port in FPR-2100 series but the lights on the port is not turning green, it stays amber all the time.
- I have connected a SFP to the port and connected a cable from the Fiber port to the switch but the light is not going green.
I am using ASA on FPR-2100 and through ASDM, I can see that the port status is enabled but the light is not turning green on the port.
Any suggestions. ??
Regards,
V
Solved! Go to Solution.
07-09-2020 08:41 PM
07-06-2020 11:12 PM
- Which FTD2100 model are you using?
- Which Fiber ports on the FTD are you using (speed)?
- What is the speed on the switch port?
- How is the port on the switch configured?
This almost sounds like there is either a speed or duplex mismatch between the FTD and the switch.
07-07-2020 04:31 PM
Hi Marius,
Thank you for the reply.
We are using the model mentioned below:-
Model | Firewall | NGFW | NGIPS | Interfaces | |
FPR-2110 | 3G | 2.3G | 2.3G | 12 x RJ45, 4 x SFP |
- using Fiber port 15, pic attached, you can see that the light is amber, not turning green.
- Speed on the switch port is 10 G, configured as a trunk port.
Just want to update you that we are using ASA IOS on this firewall, not the FXOS.
Regards,
V
07-08-2020 01:26 AM
Can you share the interface configuration from the ASA and switch?
If your switch side is setup as a trunk, do you have subinterfaces on the ASA so that the traffic is tagged?
07-09-2020 08:41 PM
09-21-2022 03:54 AM
@Visauk47 I have the same problem on a 1140 platform.
Can you elaborate on what you did to resolve the issue?
I've went into FXOS -> scope eth-uplink -> scope fabric -> scope interface 1 9
But not sure on which parameter to adjust to go from amber to green
Regards,
Michael
04-13-2023 08:02 AM
I do have the same issue. Light does not go from amber to green. Tried multiple SFP. I does get identified correctly and we've checked the incoming fiber with a light-meter. But there's no output from the Cisco. Any special configuration?
04-17-2023 12:41 AM
I don't know if it's a bug in regards to the LEDs, but the etherchannel will only use 1 link for FO/HA - this setting could explain why only one LED is on, but one every other equipment, all LEDs on a etherchannel is green.
07-04-2023 02:17 AM
I was able to use a BX-D but not BX-U, strange but it does work. Had to talk to the other party to change SFP on their end too.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide