Solved: FTD and AD sync with user agent

MMartinWV · ‎10-15-2018

I'm trying to use the AD user integration to allow certain groups to access Facebook and deny others. I realize I need AD integration with the user agent for firepower but this is a standalone FTD with no FMC as the documentation for this setup shows. Is there a way to setup the AD integration without an FMC and only using a standalone FTD. The device in questions is ASA5506x w/FPS

Marvin Rhoads · ‎10-15-2018

Cisco User Agent cannot (as of Firepower 6.2.3) integrate with locally-managed FTD devices (Firepower Device Manager) or ASA Firepower service modules (managed with ASDM).

Watch for release 6.3 (later this year) to see if that changes but you cannot currently use User Agent as an identity source unless you're using Firepower Management Center (FMC) for management.

View solution in original post

Marvin Rhoads · ‎10-15-2018

Cisco User Agent cannot (as of Firepower 6.2.3) integrate with locally-managed FTD devices (Firepower Device Manager) or ASA Firepower service modules (managed with ASDM).

Watch for release 6.3 (later this year) to see if that changes but you cannot currently use User Agent as an identity source unless you're using Firepower Management Center (FMC) for management.

MMartinWV · ‎10-16-2018

Thank you for the confirmation.