02-09-2021 07:52 AM
Hello Community
i am tryig to do PBR flex config in my lab environment .
1. I have 2 internal subnets 10.1.1.0 /24 and 192.168.1.0/24
2. i want 10.1 should take isp-1 and 192.168 should take ISP-2
3. did extended ACL and tried Flex config , but getting error while save Flex-config-object .
attached errors in attachment .
Thanks in advance for any support or suggestions .
02-09-2021 08:10 AM
Route-map object creation in the FlexConfig object is blocked, but you can use route map objects defined in the object manager inside the template as variables.
Follow the instructions in the "How to configure Policy Based Routing" section.
02-09-2021 08:24 AM
Hi Rob ,
I followed this video on how to do .
https://www.youtube.com/watch?v=lakHhw9CR5Y&t=285s
iam not sure if i missed anything . as you said Route-map object creation is blocked how can i unblock this .
Sorry if i asked something wrong .
02-09-2021 08:20 AM
not sure variable splitting some errors, make sure there is no space or extra characted added.
follow below video step by step :
https://www.youtube.com/watch?v=lakHhw9CR5Y
02-10-2021 01:31 AM
Followed exact same steps , iam not sure why this error throwing .
02-10-2021 03:23 AM
Not sure what version of FTD, may be old one dont like some syntax, as suggested, ratgher calling variable use direct command and test it.
02-09-2021 09:04 AM
02-10-2021 01:28 AM
Hi @Mohammed al Baqari ,
iam using ftd 6.2.0 and fmc also 6.2.0
is there any docs to check which version support flex config with pbr .
02-10-2021 02:08 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: