FWSM Failover configuration

[robertsoto]

Dear,

I have  two FWSM  and we want to install  the failover in the two FWSM, My FWSM has 20 interfaces are monitoring but We want only  put 9 nine interfaces VLAN with standby IP address  the Other NO, I check the configuration the guideconfiguration and always I see that configuration if for all interfaces VLAN has a Standby IP , Can I install my FWSM  olny for nine interfaces with standby IP or  must configuration all interfaces with standby IP.?

I will apreciate your very soon answer.

Thanks,

Robert Soto

[barry]

Hi Robert

This will work fine. You do not need to assign standby IPs to all interfaces.

HTH. Barry

[robertsoto]

Hello Barry,

Thanks for your Answer,  but my Other question is for the configuration in the Secondary FWSM, Could You tell me how will be the config in the FWSM secundary?.and  the replication is for la Interfaces with IP Standby?. or maybe ALL config could syncronized with the primary and both FW have the same config.

I will Apreciate your coments,

Thanks,