cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

332
Views
0
Helpful
4
Replies
qin gen
Beginner

FWSM v4.1: How to delelte a static identity NAT ?

Hi:

   In the FWSM,the version is 4.1(7),some static identidy NAT ,We need to delete;

But We can't find the command:

 

FWSM/contextA(config)# no static (inside,outside)  ?

configure mode commands/options:
  interface  Global address overload from interface
  tcp        TCP to be used as transport protocol
  udp        UDP to be used as transport protocol
FWSM/contextA(config)# no static (inside,outside) 

 

  In the other Firewall,like PIX and  ASA,We can do。

 We need help! Thanks!

4 REPLIES 4
prateek.verma
Beginner

Run the following command:

FWSM/contextA(config)# show run static

Suppose you get the following output:

static (inside,outside) 209.165.201.12 10.1.1.3 netmask 255.255.255.255

Then copy the nat statement you want to remove and run the command like below:

FWSM/contextA(config)# no static (inside,outside) 209.165.201.12 10.1.1.3 netmask 255.255.255.255

 

Regards,

Prateek Verma

Thanks。

 

Although the prompt can not be implemented, but, after the return, actually executed and entered into force.

 

Is this a known Bug?

Hi Qin,

I am not aware of that whether it is a bug or not , for that I would suggest you to open TAC case if you want to find out whether it is affected by bug or not?

Regards,

Prateek Verma

OK

Content for Community-Ad