07-14-2015 10:07 PM - edited 03-11-2019 11:16 PM
Hi:
In the FWSM,the version is 4.1(7),some static identidy NAT ,We need to delete;
But We can't find the command:
FWSM/contextA(config)# no static (inside,outside) ?
configure mode commands/options:
interface Global address overload from interface
tcp TCP to be used as transport protocol
udp UDP to be used as transport protocol
FWSM/contextA(config)# no static (inside,outside)
In the other Firewall,like PIX and ASA,We can do。
We need help! Thanks!
07-15-2015 12:54 AM
Run the following command:
FWSM/contextA(config)# show run static
Suppose you get the following output:
static (inside,outside) 209.165.201.12 10.1.1.3 netmask 255.255.255.255
Then copy the nat statement you want to remove and run the command like below:
FWSM/contextA(config)# no static (inside,outside) 209.165.201.12 10.1.1.3 netmask 255.255.255.255
Regards,
Prateek Verma
07-15-2015 02:07 AM
Thanks。
Although the prompt can not be implemented, but, after the return, actually executed and entered into force.
Is this a known Bug?
07-15-2015 02:10 AM
Hi Qin,
I am not aware of that whether it is a bug or not , for that I would suggest you to open TAC case if you want to find out whether it is affected by bug or not?
Regards,
Prateek Verma
07-15-2015 02:08 AM
OK
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide