cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
465
Views
0
Helpful
1
Replies

FWSM (where is the debug troubleshooting facilities?)

mcroft
Beginner
Beginner

Hi,

Thanks for reading ... hope someone can help.

I have just taken over some FWSM running fairly old code (3.1)

I have previously worked with ASA and PIX's, so this is fairly new to me.

I am troubleshooting some traffic issues. I noticed a few commands/tools that are not available.

There is no "debug NAT " facility unlike on the ASA's

There is no capture "match" command boo hoo.

And there is no "packet tracer" ASDM tool ..... which is a fantastic troubleshooting tool.

Any advise really really appreciated.

Thanksnat

Matt

1 Reply 1

Jennifer Halim
Cisco Employee
Cisco Employee

Sorry to disappoint, but unfortunately there won't be feature to feature parity between ASA and FWSM.

It is indeed very similar in terms of configuration, but FWSM is lacking quite a number of tools that ASA has.

FWSM will be replaced by ASA-SM which has the exact same tools as the existing ASA appliance.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers